![]()
Check the spelling of the filename and that permissions permit the TFTP server to access the file. ![]() The image filename you specified cannot be found. The UDP checksum calculation on the packet failed. This means either the local port was not the previously selected port, or the foreign port was not the TFTP port, or both. The UDP ports on either side of the connection did not match the expected values. The received IP packet's destination address did not match the address specified by the address command. The IP protocol type on the received packet was not UDP, which is the underlying protocol used by TFTP. The IP header length was not big enough to be a valid TFTP packet. The received packet was not from the server specified in the server command. The packet length as received from the Ethernet device was not big enough to be a valid TFTP packet. Timeout between the firewall and TFTP server. Receipt of non-IP packets causes the protocol number to display inside parentheses. #Tftpserver status stopped code#The error code appears inside angle brackets.įor example, random bad blocks appear as follows:Īlso, the display may show "A" and "T" for ARP and timeouts, respectively. #Tftpserver status stopped software#You must use the copy TFTP flash:pdm command described in "Installing PDM on a firewall."ĭuring a TFTP download, non-fatal errors may appear in the midst of dots that display as the software downloads. PDM cannot be downloaded via TFTP from the firewall unit's monitor mode.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |